Dryer Heats once until restart

Dryer Repair
,
1

GE Gas Dryer - Flame ignites and runs for few minutes then goes out. When ignite cycle starts again, igniter heats up but no flame for the next 10 plus minutes.
Restart cycle after 20 minutes or more and Flame ignites as before for a few minutes.

Coil or Sensor?

Thanks

3

— Begin quote from alan18;542240

GE Gas Dryer - Flame ignites and runs for few minutes then goes out. When ignite cycle starts again, igniter heats up but no flame for the next 10 plus minutes.
Restart cycle after 20 minutes or more and Flame ignites as before for a few minutes.

Coil or Sensor?

Thanks

— End quote

Alan,
Repalce the coils,

[part]AP3094251[/part]

Based on your post, the coils fail after a circuit draw, or load and opens the circuit. The circuit cools down in 20 minutes or so, and will work until the circuit opens again. You should be fine after you repalce the coils.

Thanks and Good Luck,
:slight_smile: :slight_smile: :slight_smile:

4

— Begin quote from alan18;542265

Thanks for the quick reply.

I ordered Part Number: AP2150379 Made by [AP3094251](http://www.appliancepartspros.com/frigidaire-parts.aspx"]Frigidaire. [/URL]

Will this work same as your recommended [URL="http://www.appliancepartspros.com/partsearch.aspx?pn_=AP3094251) ?

Thanks

— End quote

Alan,

Yes, either coil kit will work on your gas valve. They’re virtually the same part(s).

Thanks and Good Luck,
:slight_smile: :slight_smile: :slight_smile: