HI, It stopped working after about 4 years of service. The digital readouts in the front are dead and the compressor is not working. (warm wine…ugh).
I did verify that it is getting power. Any ideas on what I should try next?
Thanks
Bill
This is an answer to a post I submitted to Doityourself.com forum.
Doesn’t look good. I’m seeing a lot of discontinued replacement parts from Edgestar.
This unit uses three boards… power supply, control and display.
There was a kit available with all three.
Do you have any electronics knowledge ?
You need to check for voltage on the power supply board.
Don’t see any fuses for protection.