Wirlpool

Dishwasher Repair
,
1

I,

I need Help!!!

Yesterday I have to replace my motor in my dishwasher, find the part, change it and splash a gain in the machine, So now I have an other problem, I dont have anay heat on the element,

I have 13 oms for the element, I test the wiring to the control box, ok.

This morning I have pull out again my dishwasher just for checking if everithing is pluged, all ok.

What I miss!!!

:eek:

Thanks

3

Here are your parts’
An AYW3 does not come up so the parts are for an AYW2.
They are probably the same.
http://www.appliancepartspros.com/parts-for-whirlpool-wdf750sayw2.html

See the attachment for your tech sheet.

Did you check the hi-limit thermostat (item 25 in section 05).?
It should be 0 ohms.

Also it might be a good idea to check the heater circuit at the control board. P4-3 to P4-4. This will check the heater, the hi-limit and the wiring.

Also check the thermistor resistance, see the tech sheet.

4

thanks

Yes, I check them o ohms,

I check on close circuit, Item by item, The element is 13 ohms, the termal sensor is ok.

I think it is the relay. So it is weld on board.

Tahnks

5

Yes it is soldered to the board.

It may be a bad relay but also could be the electronics that control the relay